By Brands

Brands

  • Filter
Category: Mounting Kits
Created on: 01 February 2014

The WM-300 is a wall-mounting station that is built for use with the Cryo-Temp, TransiTempII, or the TransiTempII-RH. It can be mounted using the adhesive tape along the back or it can be screwed to a wall or any flat surface.

Category: Mounting Kits
Created on: 01 February 2014

Wall mount for the Therm•A•lert, Therm•A•lert-RH or Therm•A•lert-P data loggers.

Created on: 21 February 2014

4 LCD Displays with W, PF, V, A Easy Plug-in and Test RS-232 Computer Interface

Category: Wind
Created on: 31 January 2014

The Wind101A is a complete system to accurately measure and record wind speed. This low cost wind speed recording system comes complete with the Pulse101A data logger, weatherproof enclosure, a three-cup anemometer and all the necessary cabling to quickly get up-and-running. The Pulse101A data logger can measure and record data for up to 500,000 readings and the storage medium is non-volatile, solid state memory, providing maximum data security even if the battery becomes discharged. The device can be started and stopped directly from a computer using our user-friendly software.

Created on: 30 January 2014

The Wind101A is a complete system to accurately measure and record wind speed. This low cost wind speed recording system comes complete with the Pulse101A data logger, weatherproof enclosure, a three-cup anemometer and all the necessary cabling to quickly get up-and-running. The Pulse101A data logger can measure and record data for up to 500,000 readings and the storage medium is non-volatile, solid state memory, providing maximum data security even if the battery becomes discharged. The device can be started and stopped directly from a computer using our user-friendly software.

Category: Enclosures
Created on: 01 February 2014

The Waterbox110C is a water resistant enclosure designed for use with the 110 series data loggers. This enclosure provides a water tight seal, allowing non-water resistant data loggers to be used in wet environments. The Waterbox110C is machined out of black anodized aluminum, and is wall mountable. The enclosure features a water-tight communication access plug and cable gland outlet. To use, simply unscrew the 4 hex screws and insert the data logger. Loosen the compression fitting and thread the sensor lead wire through the fitting. Attach the probe to the data logger and insert, then tighten the six screws again and it’s ready to use.

Category: Mounting Kits
Created on: 01 February 2014

The Waterbox110C is a water resistant enclosure designed for use with the 110 series data loggers. This enclosure provides a water tight seal, allowing non-water resistant data loggers to be used in wet environments. The Waterbox110C is machined out of black anodized aluminum, and is wall mountable. The enclosure features a water-tight communication access plug and cable gland outlet. To use, simply unscrew the 4 hex screws and insert the data logger. Loosen the compression fitting and thread the sensor lead wire through the fitting. Attach the probe to the data logger and insert, then tighten the six screws again and it’s ready to use.

Category: O-Rings
Created on: 01 February 2014

One set of replacement o-rings for the Waterbox110.